Partitioning The Devices; Creating The File Systems - HP XP20000/XP24000 Configuration Manual

1. "Partitioning the devices" (page 84)
2. "Creating the file systems" (page 84)
3. "Creating the mount directories" (page 85)
4. "Creating the mount table" (page 85)
5. "Verifying file system operation" (page 86)
Creating scripts to configure all devices at once could save you considerable time.

Partitioning the devices

In a Linux environment, one LUN can be divided into a maximum of four primary partitions (using
fdisk) or maximum of one extended partition.
After the device parameters have been set, the next step is to set the partitions. To partition the
devices:
1. Enter fdisk/dev/device_name.
Example
# fdisk/dev/sda
2. Select p to display the present partitions.
3. Select n to make a new partition. You can make up to four primary partitions or you can make
one extended partition. The extended partition can be divided into a maximum of 1 1 logical
partitions, which can be assigned partition numbers from 5 to 15.
4. Select w to write the partition information to disk and complete the fdisk command.
5. Other commands that you might want to use include:
d to remove partitions
q to stop a change
6. Repeat steps 1–5 for each device.

Creating the file systems

The supported file system for Linux is ext2.
84 Linux