Configuring The Fibre Channel Ports - HP XP20000/XP24000 Configuration Manual

CAUTION:
to Linux hosts. Do not select a mode other than 00 for Linux. Changing a host mode after the host
has been connected is disruptive and requires the server to be rebooted.
When a new host group is added, additional host group modes (options) can be configured. The
storage administrator must verify if an additional host group mode is required for the host group.
The following host group mode (option) is available for Linux:
Table 25 Host group mode (option) Linux
Host Function
Group
Mode
7 Reporting Unit Attention when adding LUN
CAUTION:
configured is disruptive and requires the server to be rebooted.

Configuring the Fibre Channel ports

Configure the disk array Fibre Channel ports by using P9000 or XP Command View Advanced
Edition Software or XP Remote Web Console (shown). Select the settings for each port based on
The correct host mode must be set for all new installations (newly connected ports)
Changing host group modes for ports where servers are already installed and
Default Comments
Inactive Previously MODE249
Installing and configuring the disk array 1 17