Performing A New Installation Of Hdlm On Windows Server 2003; In A Non-Cluster Environment - Hitachi XP P9500 User Manual

A folder specified in the workdir key (if the workdir key has not been
specified, a folder specified in the TMP or TEMP environment variable)
must have at least 20 KB of free disk capacity.
• Information for the HDLM operation can also be specified by using the
HDLM command's set operation. To specify the information by using this
way, see
untended installation is completed.
For details about what can be defined in a installation-information settings
file, see
7-17.
For details about the set operation of the HDLM command, see
Up the Operating Environment) on page

Performing a New Installation of HDLM on Windows Server 2003

In a Non-Cluster Environment

Before installing HDLM, have a license key ready.
If you want to perform an unattended installation, also be sure to prepare an
installation-information settings file.
To install HDLM on a host that does not currently have HDLM installed
on it:
1 Log on to Windows as a member of the Administrators group.
.
2 Save the license key file directly under the Windows installation-
.
destination drive.
installation-drive:\hdlm_license
The license key file will be deleted after the installation finishes.
3 Perform the installation.
.
¢
¢
3-28
Setting Up HDLM on page 3-68
Contents of an Installation-Information Settings File on page
If you are not performing an unattended installation, insert the DVD
into the drive.
In the displayed window, click the Install button next to for
Windows of Hitachi Dynamic Link Manager Software.
If no window is displayed, manually run the installer (setup.exe).
The program checks whether HDLM has already been installed. If
HDLM 5.4 or earlier has been installed, the KAPL09129-E message will
appear. If this happens, carry out the procedure shown in
from HDLM 5.4 or Earlier to HDLM 5.5 or Later on page
HDLM 5.5 or later has been installed, the KAPL09173-W message will
appear. If this happens, carry out the procedure shown in
Installation or Re-installation of HDLM on page
appears, go to step 4.
If you are planning to perform an unattended installation, execute the
installhdlm utility.
At the command prompt, execute the following command:
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Windows(R))
and make sure that an
6-15.
3-64. If
3-63. If no message
set (Sets
Migrating
Upgrade