Hitachi XP P9500 User Manual page 124

20 Make sure that all the hosts in the cluster system have completely shut
.
down.
21 Restart each host.
.
22 Log on to Windows again as a member of the Administrators group.
.
23 Execute the dlnkmgr command's view operation to display the status of
.
each program.
An example of executing the dlnkmgr command's view operation is as
follows:
>dlnkmgr view -sys
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size (KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Remove LU
Intermittent Error Monitor
HDLM Manager Ver
Alive
HDLM Alert Driver Ver
Alive
HDLM Driver Ver
Alive
License Type Expiration
Permanent
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time = yyyy/mm/dd hh:mm:ss
24 Use the results of the view operation to check the version of the installed
.
HDLM.
If x.x.x-xx is displayed in HDLM Version, the correct version of HDLM
has been installed.
25 From the results of the view operation, check that the programs are
.
running properly.
If HDLM Manager, HDLM Alert Driver, and HDLM Driver are all Alive, all
the programs are running correctly.
26 After the installation finishes, check the path information as described in
.
Checking the Path Configuration on page
have successfully installed HDLM in a single-path configuration.
27 Connect cables to all the HBAs to change the configuration to a multi-path
.
configuration.
28 Check the path information as described in
.
Configuration on page 3-68
assembled a multi-path configuration.
3-58
x.x.x-xx
x.x.x-xx
x.x.x-xx
-
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Windows(R))
: x.x.x-xx
:
: on(extended lio)
: off
: 3
: 9900
: 2
: 0
: 1000
: 4
: on(30)
: on(1)
: off
: off
WakeupTime
yyyy/mm/dd hh:mm:ss
WakeupTime
yyyy/mm/dd hh:mm:ss 128
WakeupTime
yyyy/mm/dd hh:mm:ss
3-68, and make sure that you
Checking the Path
to make sure that you have successfully
ElogMem Size