Checking The Updated Settings - Hitachi XP P9500 User Manual

7
Table 3-19 Values Indicating Audit Log Data Categories on page 3-78
describes the values that indicate audit log data categories. The default is
all.
Value
ss
c
ca
all
This example shows how to enable the collection of audit log data:
>dlnkmgr set -audlog on -audlv 6 -category all
Specify on if you want to collect audit log data, and off if you do not want to
collect audit log data. If you specify on, you can use the –audlv parameter to
specify the collection level for audit log data and the –category parameter to
specify the audit log categories.

Checking the Updated Settings

This chapter describes how to check the updated settings by using the
dlnkmgr command's set operation after settings have been changed.
When you change some settings, you can display information about all of
HDLM function settings. The following shows an example of executing the
command:
>dlnkmgr view -sys -sfunc
HDLM Version
Service Pack Version
Load Balance
Support Cluster
Elog Level
Elog File Size(KB)
Number Of Elog Files
Trace Level
Trace File Size(KB)
Number Of Trace Files
Path Health Checking
Auto Failback
Remove LU
Intermittent Error Monitor
3-78
Value (severity)
Table 3-19 Values Indicating Audit Log Data Categories
Audit log events of the StartStop category are collected.
Audit log events of the Authentication category are collected.
Audit log events of the ConfigurationAccess category are collected.
Audit log events of the StartStop, Authentication, and
ConfigurationAccess categories are all collected.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Windows(R))
Explanation
Explanation
: x.x.x-xx
:
: on(extended lio)
: off
: 2
: 1000
: 5
: 1
: 2000
: 10
: on(10)
: on(10)
: on
: on(2/20)