Ericsson Dialog 3213 User Manual page 74

Programming and Adjustments
c d
1 2
f g
4 5
b +c
7 8
74
Activate or deactivate a stored melody
A stored melody has to be activated in melody mode to be heard
when you get an incoming call.
To activate (in melody mode):
Press the key for the requested type of call (Access 1 or
Access 2 or Inquiry)
The corresponding key lamp is switched on:
Access 1 key = Internal calls
Access 2 key = External calls
Inquiry key = Callback calls
Note: If you want to return to an ordinary ringing singnal
but keep the melody stored, just press the key for the
requested type of call again. When key lamp is off the
stored melody is deactivated.
#
Press to exit melody mode
To enter notes
In melody mode, the keypad is used to enter notes, pauses, etc.
A maximum of 40 notes can be programmed for incoming calls,
and 20 notes for recalls.
This is how the keys are used:
e
3
a
6
Press to insert notes (1-9)
+d
9
Note: A short press gives a short note, a long press gives
a long tone (displayed by a capital letter), +c and +d means
the higher octave.
*
Press to insert a short pause (p)
Hold to get a long pause (P). Repeat to get a longer pause (pp...p).
0
Press to get a higher octave for the inserted note
A + is shown in front of the note to indicate the higher octave.
Example: 30 to get +e
#
Press to increase or decrease the pitch for the inserted note
Press once for sharp pitch, twice for flat pitch and three times to
get the normal pitch.
Dialog 3213