Hoover FloorMate SpinScrub 800 Manual page 18

Use the list below to help solve minor problems.
C]eaner won't run
Low suction
Water puddling behind cleaner
Won't pick tap dirty solution
Cleaner pushes a line of dry debris
in front of it
Cleaning solution won't dispense
Brushes won't rotate
18
,/Make sure the cleaner is
plugged in firmly.
/ Check the fuse or breaker.
V"Empty the recovery tank; it may be full
andthe automatic shut-off engaged.
¢" Make sure filter and filter" lid are properly
positioned.
,/Make sure tanks are locked in place.
¢" Check the filter" and clean if dirty.
,/Make sure nozzle is replaced properly
and locked.
,/Make stare the hose door is closed tightly
when not using the hose.
¢" Use recommended detergents to reduce
excess foaming.
,/Make sure solution tank is installed
properly.
,/Empty recove W tank.
,/Check Mode selector dial to ensure it is
set for WET PICKUR
,/Make sure recovery tank is installed
properly.
,/Empty recovery tank.
,/Make sin> filter and filter lid are properly
positioned.
,/Check Model selector dial to ensure it is
set for DRY VAC.
V" Tip nozzle off floor by pushin_ down on
handle to pick up debris that i_ too large
to clear the squeegee.
¢" Make sure solution tank is locked in
position.
¢" Refill the solution tank if it is empty.
¢" Puu)pneeds to be, primed (when using
tool). See page
lb.
_" Check Mode selector dial to ensure it is
set for WASH.
¢' Reset circuit breaker'.
(1) Push ON/OFF switch to turn cleaner
OFE
21
nplug the <:leaner'.
Walt one minute.
Plugthe cleaner into electrical outlet.
,5 Pus];r the
ON/OFF switch
again
to
turn cleaner ON.
If the brushes continue to stall and the
breaker trips again, clean the brushes to
remove
debris.