Related Manuals for Hoover FloorMate SpinScrub FH40000
Summary of Contents for Hoover FloorMate SpinScrub FH40000
- Page 1 ENGLISH "_ pp. 1-19 ® ESPANOL _ p_g. 20-31 FloorMate SpinScrub Hard Floor Cleaner...
-
Page 2: Important Safeguards
Do not run apphance over water, take it to a Hoover Stiles and cord. Keep cord away from heated Service Center or Authorized surfaces. Hoover Warranty Service Dealer. A temporary... -
Page 3: Table Of Contents
A. Hard floor cleaner B. Upper handle C. Brush assembly D. Nozzle E. Floor cleaning concentrate *Some models include second set of brushes (gray bristles) for cleaning grout and Grout Cleaner © 2007 Hoover, Inc. hoover.corn Continued... -
Page 4: Cleaner Description
T_his cleaner is intended for household use. Operate cleaner only at voltage speci- fied on data plate on back of cleaner. Plug cleaner into a properly grounded outlet. This user manual applies to models with either 6 or 7 brushes. Features Nozzle Soft hand... -
Page 5: Assembly Handle Assembly
Assemble handle Rotate bottom handle support up to the upright position until snap is felt. lign control rod (B) on upper han- dle (C) with slot in bottom handle support (D). ush upper handle (C) all the way down until you hear it snap place. - Page 6 Press brush assembly firmly p into place. To install nozzle, make sure latches (C) are out. Align middle section (D) of nozzle with opening (E) on cleaner. Remove cardboard packing insert from squeegee area on underside of nozzle. While holding nozzle in place, slide latches...
- Page 7 H naio re o se p eaa Step on pedal (A) to lower handle to operating position. Handle does not lock into a single position, "floats" to allow convenient operation. 0N/OFF switch ush switch (A) once to turn cleaner ON. Push switch again to turn cleaner...
-
Page 8: Mode Selector Dial
Your HOOVER FloorMate SpinScrub Cleaner can be used to both vacuum dry debris and wet clean non-carpeted floor surfaces such as vinyl, tile and sealed wood. It is not intended for use on carpet or rugs. CAUTION: To prevent damage... -
Page 9: Solution Tank
(2 oz.) HOOVER@ Floor to Floor Cleaner. Check for worn spots or joint separations before using, as these conditions could lead... - Page 10 DO NOT use cleaning concentrates that contain solvent based ingredients. CAUTION: HOOVER® Grout Cleaner* cannot be used in Hoover SteamVac products. Doing so could damage your SteamVac Cleaner. *Available at additional cost if not included with your model. Pour cleaning concentrate into tank (B).
-
Page 11: Recovery Tank
Recovery (lower) tank Automatic shut-off An automatic suction shut-off is built into the recovery tank to prevent the tank from overflowing. When the shut-off activates, the cleaner will not pick up debris and the sound of the motor will change. The recov- ery tank is full and must be emptied. -
Page 12: Recommended Cleaning Sequence
Recommended cleaning sequence Use your HOOVER® FloorMate SpinScrub Cleaner • Dry Vacuum to remove loose dirt, hair and debris. • Wet Clean the floor surface. The brushes will provide light agitation to help loosen dirt. -
Page 13: Cleaning Floors
Cl eani g floo s NOTE: Your HOOVER® FloorMate SpinScrub cleaner may be used to clean wood floors that have been sealed with a polyurethane coating and can be cleaned with water. CAUTION: To prevent damage to wood floors, follow... -
Page 14: Storage
Before storing cleaner: Turn cleaner OFF and disconnect from electrical outlet. • Empty and rinse solution and recovery tanks. Allow to air dry. Press on upper handle release button to lower handle storage. Make sure that nothing is pressing on the nozzle squeegee. - Page 15 To replace nozzle, make sure latches (D) are out. Cleaner should be in the upright position for easier assem- bly of the nozzle. Align middle section (E) of nozzle with opening (F) on cleaner. While holding nozzle in place, slide latches inward to lock place.
-
Page 16: Cleaning The Brushes
Cleaning the brushes The brush assembly can be removed for easy cleaning. Turn cleaner OFF and disconnect from electrical outlet. Place handle in the upright position. Remove tanks to prevent leaking. Set aside. Pull the two nozzle release buttons (A) out. Remove nozzle. -
Page 17: Troubleshooting
the list below to help solve minor problems. What!s the problem? What to do ¢" Make sure the cleaner is Cleaner won't plugged in firmly. ¢" Check the fuse or breaker. Low suction ¢" Empty the recovery tank; it may be full ant{ the automatic shut-off engaged. -
Page 18: Service
Hoover Sales and Service Center or Authorized Hoover Warranty Service Dealer (Depot) ¢" Checldng the Service Section of Hoover on-line at hoovencom ¢" Checking the Yellow Pages under "Vacuum Cleaners - Household" •/ Calling 1-800-944-9200 for an automated... -
Page 19: Warranty
This warranty does not cover pick up delivery, or house calls; however, if you mailyour appliance to a Hoover Sales and Service Center for warranty service, transportation wilt be paid one way. While this warranty gives you spe-...