Hoover FloorMate SpinScrub 800 Manual page 12

Dry or loose debris will also collect on the filter screen located
in the tank lid.
To remove debris from screen, remove the pleated filter
the lid. Remove debris from screen (D).
The filter screen may also be cleaned by rinsing it under
running water.
Reposition pleated filter in lid. Replace lid onto recovery tank,
pressing down firmly until snapped in place.
\
To replace recovery tank, place bottom of tank behind
ledge (E) and push tank straight into cleaner body until it is
locked in place.
E_
J
Recommended cleaning sequence
Use your HOOVER') FloorMate
TM
SpinScrub
TM
800 Cleaner to:
o Dry Vacuum to remove loose dirt, hair and debris.
• Wet Clean the floor surface. The brushes will provide light agitation to help loosen dirt.
, W'et Pickup reduces drying time of the floor surface.
/
The Mode selector dial turns the brushes on and off.
, debris pickup, turn the dial to the DRY VAC posi-
In this position, the brushes will not rotate and are
raised off the floor surface.
To wet clean with brushes turned ON, turn the dial to the WASH
position (B).
For wet pickup, turn the dial to the WET PICKUP position (C).
12