Power Outage - GE JGB900 Owner's Manual & Installation Instructions

Usingthe oven.
Toavoid possible bums, place the shelves in the desired position before you turn the oven on.
Before you begin...
The shelves have stop-locks, so that when
placed correctly on the shelf supports (A
through E), they will stop beiore coming
completely out, and will not tilt.
When placing and removing cookware,
pull the shelf out to the bump on the shelf
suI_port.
To remove a shelf, pull it toward you, tilt the
fl'ont end up and pull it out.
To replace, place the end of the shelf (stoi>
locl_s) on the sui)port, tilt up the fl'ont and
push the shelf in.
NOTE: Theshelf is not desl)ned to slide out at the
special low shelf (R)position.
The oven has 5 shelf positions.
It also has a special low shelf
position (R)for extra large items,
such as a large turkey.
Plastic items on the cooktop may
melt if left too close to the vent.
Vent appearance and location var_
Oven Vent
Your oven is vented through ducts at the
rear of the range. Do not block these ducts
when cooking in the oven--it is important
that the flow (ff hot air ti'om the oven and
ti'esh air to the oven burner be
uninterrui_ted. Avoid touching the vent
openings or nearby stlrtilces during oven or
broiler operation--they may become hot.
Handles of potsandpanson thecooktop may
become hot if left toodose to thevent
Donotleaveplasticor flammable itemson the
cooktop--theymaymelt or igniteif left toodose
to thevent
Donotleavec/osed containers on thecooktop.
Thepressure lb closed contalbers mayincrease,
whichmaycausethemtoburst.
Metal itemswill become very hot if theyareleft
on thecooktop, a ndcouldcause burns.
Power Outage
CAUTION: Do not make any attempt to operate the
electric ignition ovenduring an electricalpower
failure.
The oven or broiler cannot be lit during a
power fidlure. Gas will not flow unless the
glow bar is hot.
If the oven is in use when a power tailure
occm_, the oven burner shuts off and
cannot be reqit until power is restored. This
is because the flow of gas is automatically
stopped and will not resume when power is
restored tmtil the glow bar has reached
operating temperature.
Oven Light
Touch the OVEN LIGHTpad on the uI)per
control panel to turn the light on or off'.
On some models, the OVEN LlOHTswitch is
on the lower fl'ont control panel.
12