GE JGB900 Owner's Manual & Installation Instructions page 37

www.GEAppliances.com
Vent appearance and location var_
Oven Air Vents
Never block the vents (air openings) of the
range. They provide the air inlet and outlet
that are necessa_ T fin" the range to operate
properly with correct COll/btlstlon.
_dr openings are located at the rear ot
the cooktop, at the top and bottom ot the
oven doo_; and at the bottom of the range,
under the wamfing drawer
CONTROL LOCKOUT
Upper Control Panel
On models so equipped, lock out the touch
pads before cleaning.
See the Control Lockoutinlbmmtion in the
Special features of your oven control section
in this manual.
Clean up splatte_ with a damp cloth.
Yell I/laY also rise a
glass
cleanei:
Remove heavier soil with warn/soapy water:
Do not rise abrasives ot any kind.
Unlock the touch pads after cleaning.
PullflTeknobstraightoff the stem.
Lower Control Panel (Front Manifold Panel) and Knobs
It's a good idea to wipe the control panel
atter each use of the oven. Use a damp
cloth to clean or rinse. For cleaning, use
mild soap and water or a 50/50 solution el
vinegar and wam_: For rinsing, use clean
water: Polish dry with a soft cloth.
Do not use abrasive cleansers, strong liquid
cleane_, plastic scouring pads or oven
cleane_ on the control panel--they will
damage the finish.
Do not try to bend knobs by pulling them
up or down or by hanging a towel or other
such loads. This can damage the gas \;dye
shaft.
The control knobs may be removed fin"
easier cleaning. To remove a knob, pull it
straight off the stem. If knob is difficult [o
remove,
place
a towel or
dishcloth
between
the knob and control panel and pull genfl>
Wash the knobs in soap and water or a
vinegar and hot water solution,
Metal parts can be cleaned with soap and
water: Do not use steel wool, abrasives,
}lI//IllOIli}l_
acids or coi//illeF(-'ial oven
cleane_. Dry with a soft cloth.
37