GE JGB900 Owner's Manual & Installation Instructions page 53

www.GEAppliances.com
Possible Causes
Displaygoesblank
A fuse in your home may be
blown or the circuit
breaker tripped.
The clock is in the
* See
tile
Special features of your oven control
se(tiou.
black-out mode.
Display flashes
Power failure.
* Reset
tile clock.
Unable to get the Oven control pads were * Tile BAKE and BROIL HI/LO pads must be touched :it
display to show "SF"
not pressed properly, tile same time mad held for 3 secou(ls.
Power outage, Power outage or surge. * Reset tile clock. If the oven was in tlSe vot/l///lst Yeset
clock flashes
it 1)y touching
the
CLEAR/OFFpad,
setting the clock
and resetting any cooking flmctiou.
"Burning" or "oily" This is normal in a new oven * To speed the process, set a sell:clean cycle
fin" a
odor emitting from
and will disappear in time. minimum of 3 hem's. See the
Using the self-cleaning
the vent oven section.
Strong odor
An odor from the insulation * This is teu/l)orary.
aromzd the inside of the oven
is normal for the first few times
the oven is used.
Fan noise (some models) The convection fan may turn on * This is normal. The convection thu will mu until the
and off automatically, flmctiou is over or the door is opened.
Convection fan not Preheat temperature * Fan will start automatically once the preheat
working (some models) not reached, temperature is reached.
Drawer does not slide The drawer is out of afigmnent. * Fully extend the drawer and push it all the way in.
smoothlyor drags See the Care and cleaning of the range section.
Drawer is over-loaded or load * Reduce weight. Redistrilmte drawer contents.
is unbalanced.
Warming drawer will
A fuse in your home may be
* Replace
the fi/se or reset the circtfit breaker.
not work
blown or the circuit breaker
tripped.
The oven is self-cleanh_g. * Wait fin" the sell=clean cycle to finish and the oveu
to cool.
Controls improperly set. * See the
Electric warming drawer
section.
Excessive condensation Liquid in warming drawer. * Remove liquid.
in the
warming
drawer
Uncovered foods. * Cover fi)od with lid or alumiutun foil.
Temperature setting too high. * Reduce temperature setting.
Food dries out in the
Moisture escaping. * Cover food with lid or alumiutun fi)il.
warming drawer
What To Do
• Replace the filse or reset the (irctfit breaker:
53