Control Panel Assembly - Dell PowerEdge R415 Owner's Manual

11 If applicable, replace the system board shroud. See "Installing the System
Board Shroud" on page 110.
12 If applicable, reconnect the cables.
13 Close the system. See "Closing the System" on page 83.
14 Enter the System Setup program to confirm that the battery is operating
properly. See "Entering the System Setup Program" on page 58.
15 Enter the correct time and date in the System Setup program's Time and
Date fields.
16 Exit the System Setup program.

Control Panel Assembly

NOTE:
The LCD control panel assembly consists of two separate modules—the
display module and the control panel circuit board. Use the following instructions to
remove and install either module.
Removing the Control Panel Assembly
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product
1 If applicable, remove the front bezel. See "Removing the Front Bezel" on
page 81.
2 Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
3 Open the system. See "Opening the System" on page 82.
4 Disconnect the control panel cable from the control panel board.
• For LED control panel, see Figure 3-28.
• For LCD control panel, see Figure 3-29.
CAUTION:
Do not pull on the cable to unseat the connector. Doing so can damage
the cable.
5 Press the metal tabs on the ends of the cable connector.
Installing System Components
135