Raid Battery (Optional) - Dell PowerEdge R415 Owner's Manual

Installing a Cooling Fan
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
1 Ensure that the fan is oriented correctly.
Orient the fan module so that the side with the power cable faces towards
the back of the system.
2 Slide the fan module into the fan assembly until the fan is fully seated.
See Figure 3-20.
3 Connect the fan's power cable to the power connector on the system
board.
4 Replace the system board shroud or the power distribution board shroud as
applicable. See "Installing the System Board Shroud" on page 110 or
"Installing the Power Distribution Board Shroud" on page 112.
5 Close the system. See "Closing the System" on page 83.

RAID Battery (Optional)

Removing the RAID Battery
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
NOTE:
The information in this section applies only to systems with the optional
PERC controller card.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Open the system. See "Opening the System" on page 82.
Installing System Components
119