Processors - Dell PowerEdge R415 Owner's Manual

5 Press down and out on the ejectors on each end of the socket until the
memory module pops out of the socket. See Figure 3-22.
Handle each memory module only on either card edge, making sure not to
touch the middle of the memory module.
6 Replace the system board shroud. See "Installing the System Board
Shroud" on page 110.
7 Close the system. See "Closing the System" on page 83.

Processors

Removing a Processor
CAUTION:
Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is
not covered by your warranty. Read and follow the safety instructions that
came with the product.
1 Prior to upgrading your system, download the latest system BIOS version
from support.dell.com and follow the instructions included in the
compressed download file to install the update on your system.
2 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet. When disconnected from AC power,
press and hold the power button for 3 seconds to fully drain the system of
stored power prior to removing the cover.
NOTE:
It is recommended that you always use a static mat and static strap while
working on components in the interior of the system.
3 Open the system. See "Opening the System" on page 82.
4 Remove the system board shroud. See "Removing the System Board
Shroud" on page 109.
WARNING:
system has been powered down. Allow the heat sink and processor to cool before
handling them.
CAUTION:
Never remove the heat sink from a processor unless you intend to
remove the processor. The heat sink is necessary to maintain proper thermal
conditions.
The heat sink and processor are hot to touch for some time after the
Installing System Components
127