Prior To Entries; Preparations For Entries; Connecting The Printer And Installing The Paper Rolls (For; Receipt Paper Roll (For - Sharp UP-800F Instruction Manual

4

Prior to Entries

Preparations for Entries

■ Connecting the printer and installing the paper rolls (for UP-800F)
Before using the POS terminal UP-800F, connect the printer and install paper rolls. For those operations,
see the printer's manual.
■ Receipt paper roll (for UP-810F)
If the receipt paper roll is not set in the machine or it is getting low, install a new one according to section
"Installing and Removing the Paper Roll" under "Operator Maintenance."
■ Receipt ON/OFF function (for UP-810F)
You can disable receipt printing in the REG mode to save paper using the receipt function. To disable
receipt printing, press the
indicator "R" is highlighted.
Your register will print reports regardless of the receipt state. This means that the receipt roll
NOTE
must be installed even when the receipt state is "OFF".

■ Clerk assignment

Prior to any item entries, a clerk must enter his/her clerk codes into the POS terminal. On your POS
terminal, you have four systems to enter your clerk code. You can use any of the following systems to
assign your clerk code.
Contactless clerk key system (factory default)
This system allows clerks to be assinged by setting corresponding contactless clerk keys. Any registration
cannot be performed unless a contactless clerk key is set.
* The contactless clerk key is optional.
Clerk code entry system (factory default)
If you select this system, clerks can be assigned by entering his or her clerk code in advance.
To sign on:
To sign off:
˚
Clerk entry key system (factory default)
If you select this system, clerks can be assigned by pressing corresponding clerk keys on the keyboard.
To sign on:
To sign off:
˚
‰
key to select "OFF". When the function is in the OFF status, the receipt off
˚
Clerk code
Q R
through Secret code
(In case secret code is 0000)
e
Secret code
(In case secret code is 0000)
e
29