Prior To Making Entries; Preparations For Entries; Receipt Paper Roll; Receipt On/Off Function - Sharp ER-A247 Instruction Manual

3
Prior to Making Entries
Preparations for Entries
■ Receipt paper roll
If the receipt paper roll is not set in the register or it is getting low, install a new one according to section
"Replacing the Paper Roll" under "Operator Maintenance."
■ Receipt ON/OFF function
You can disable receipt printing in the REG mode to save paper using the receipt function.
Press the key. Select "2 RECEIPT SW" and press the
H
printing and press the
highlighted.
Your register will print reports regardless of the receipt state. This means that the receipt roll
NOTE
must be installed even when the receipt state is "OFF".
■ Clerk assignment
Prior to any item entries, a clerk must enter his/her clerk codes into the register.
To sign on:
Clerk code
L
To sign off:
Error Warning
In the following examples, your register will go into an error state accompanied with a warning beep and the
error message on the display. Clear the error state by pressing the
to remedy the problem.
• When you exceed a 32-digit number (entry limit overflow):
Cancel the entry and reenter a correct number.
• When you make an error in key operation:
Clear the error and try the entry again.
• When you make an entry beyond a programmed amount entry limit:
Check to see if the entered amount is correct. If it is correct, it can be rung up in the MGR mode.
Contact your manager.
• When an including-tax subtotal exceeds eight digits:
Clear the error message by pressing the
transaction.
A key. When the function is in the OFF status, the receipt off indicator "R" is
L
A key. Select "OFF" to disable receipt
(In case secret code is 0000)
A
Secret code
l key and then take the proper action
l key and then press a media key to finalize the
13