Add-On Code; Ean File - Sharp UP-800F Instruction Manual

■ Add-on code

UPC-A and EAN-13 may be followed by a two digits number or a five digits number as add-on code,
excepting UPC-A without a check digit plus two or five digits add-on code.
Therefore, the total number of digits enterable for sales entries are as shown below:
Code entry
UPC-A
UPC-A w/leading zero
UPC-A w/o check digit
UPC-E
EAN-8
EAN-13
Your register automatically judges the add-on code in an EAN code entered from the total
NOTE
number of digits and the flag.

■ EAN file

Your POS terminal has an EAN main file and can provide a Dynamic EAN (D-EAN) file.
EAN main file
In general use, all EAN items are managed in the EAN main file.
The programming data and sales information is recorded in the EAN main file.
Dynamic EAN file
If an dynamic EAN file is allocated, the items entered by EAN learning function (refer to "EAN learning
function" section.) are saved in this file temporarily. (If not generated, they are directly saved in the EAN
main file.) The data saved temporarily can be transferred to the EAN main file when necessary by
executing D-EAN LOAD in the PGM2 mode.
If you want to use the dynamic EAN file, consult your authorized SHARP dealer.
No add-on code 2-digit add-on code
12
13
11
6
8
13
5-digit add-on code
14
15
–
–
–
15
17
18
–
–
–
18
223