Sharp IM-DR420H Operation Manual page 35

! Sound-actuated recording
(Mic Synchronised recording)
1
Press the REC button.
2
Select the mic recording level from auto or manual
adjustment (steps 4 - 8, page 26).
3
Select the recording mode (steps 1 - 5, page 21).
4
Press the MENU/ENTER button.
5
Press the or button repeatedly to select "SYNC
ON".
6
Press the MENU/ENTER button.
7
Press the or button to select the recording start
level.
MIC SYNC H :Recording starts when the unit detects - 24
dB or more (the unit can start recording
from quiet sounds).
MIC SYNC L : Recording starts when the unit detects - 12
dB or more.
8
Press the MENU/ENTER button.
9
When a sound, such as person speaking, is picked up
by the microphone, recording will begin automatical-
ly.
IM-DR420H TINSZ0964AWZZ
About pause function
The unit automatically pauses when the microphone
does not pick up any sound for 3 seconds or more.
(Pause function does not work for approximately 10 sec-
onds after a recording starts.) When the microphone
picks up sound again, recording starts automatically.
Notes:
" Whilst making a mic recording, do not connect any-
thing to the OPTICAL/LINE IN socket on the portable
MD.
" To use a microphone, be sure it is a plug-in-power
type microphone.
- When a plug-in-power type microphone is plugged in,
the portable MD will provide power for the micro-
phone's operation.
- If a different type of microphone is plugged in, it may
not operate properly or it may cause the unit to mal-
function.
" Insert the plug firmly. If you don't, the recording will not
be made properly.
" Use a microphone with a 3.5 mm (1/8") diameter ste-
reo mini plug.
" If the unit starts recording too often from low unwanted
noises, set the microphone input to "MIC SYNC L".
" Recording sensitivity can be changed whilst recording.
" When using a microphone, do not bring too close
to the unit. Also do not use a plug-in type (without
lead). Noise pickup may occur.
03/7/21 IM-DR420H_SEEG_E.fm
IM-DR420H
ENGLISH
E-28