Before Recording - Sharp IM-DR420H Operation Manual

Before Recording

! About the TOC
Whilst recording or editing, "TOC" (Table Of Contents)
appears. If you stop recording or turn off the power after edit-
ing, TOC will be written on the MD ("TOC" will flash followed
by "TOC EDIT!"). During the process, the lid is locked and
you cannot remove the MiniDisc.
TOC display
Warning:
If the power is removed (Battery/AC adaptor) whilst
"TOC" is displayed, the MiniDisc unit lid will remain
locked until the battery/main power is restored and the
unit is turned on. Your new recordings or edited changes
will be lost and your MiniDisc may become unusable.
Caution:
Whilst "TOC" or "TOC EDIT!" is displayed, follow the instruc-
tions below.
- Do not jerk or bump the unit.
- Do not unplug the AC adaptor.
- Do not remove the battery.
- Do not subject the unit to shock.
9
Otherwise, tracks may not be recorded properly.
IM-DR420H TINSZ0964AWZZ
! To prevent recorded MiniDiscs from being
erased accidentally
Slide the accidental erase prevention tab, located on the
side of the MiniDisc, in the direction indicated by the
arrow.
The MiniDisc will then be protected against accidental
erasure.
Recording
Recordable
prevented
To add a recording to such a MiniDisc, slide the acciden-
tal erase prevention tab back to its original position.
! Helpful tip when attaching a label
When attaching a label to a MiniDisc cartridge, be sure to
note the following. If the label is not attached properly, the
MiniDisc may jam inside the unit and you may not be able
to remove it.
" If the label peels off or partially lifts
away, replace it with a new one.
" Do not put a new label on top of an ex-
isting one.
" Attach the label only in the specified
location.
03/7/21 IM-DR420H_SEEG_E.fm
IM-DR420H
ENGLISH
E-14