Table of Contents
Advertisement
Projection stops automatically
Is sleep mode active?
Problems when projection starts
Power does not turn on
Have you pressed the [Power]
button?
Is "Child Lock" set to "ON"?
Is "Key Lock" set to "ON"?
Are all of the indicators
switched off?
Do the indicators turn off and
on when the power cable is
touched?
Problems with the remote control
The remote control does not work
Is the remote control light-
emitting area facing towards the
remote control light-receiving
area when it is operated?
Is the remote control too far
from the projector?
Is direct sunlight or strong
light from fluorescent lamps
shining onto the remote
control light-receiving area?
Are the batteries dead, or have
the batteries been inserted
correctly?
When "Sleep Mode" has been set to ON, the lamp turns off
automatically if no signal is input for about 30 minutes, and the
projector switches to standby mode. Press the
control or the
button on the projector's control panel to turn the
projector's power back on. To cancel the sleep mode setting, change
"Sleep Mode" menu command to "OFF".
"Setting" - "Operation" - "Sleep Mode" p.19
Press
on the remote control or
If the "Child Lock" menu command is set to "ON", press
projector's control panel for about 3 seconds or press
control to turn the power on.
"Setting" - "Operation" - "Lock Setting" - "Child Lock" p.20
If the "Key Lock" menu command is set to "ON", all buttons on the
projector's control panel are disabled. Press
"Setting" - "Operation" - "Lock Setting" - "Key Lock" p.20
Disconnect the power cable and then reconnect it.
Check the circuit breaker to see if power is being supplied.
Turn the power off, disconnect the power cable and then reconnect it. If this
does not solve the problem, there may be a problem with the power cable. Then
contact your dealer or the nearest address provided at "International Warranty
Conditions" in Safety Instructions/World-Wide Warranty Terms booklet.
Face the remote control towards the remote control light-receiving area.
The operating angle for the remote control is approximately ±30°
horizontally and approximately ±30° vertically.
Setup Guide
The operating range for the remote control is approximately 10m.
Setup Guide
Set the projector up in a location where strong light will not shine onto
the remote control light-receiving area.
Insert new batteries, while making sure that they face correctly.
Setup Guide
Problem Solving
button on the remote
on the projector's control panel.
on the
on the remoto
on the remote control.
Setup Guide
35
Advertisement
Table of Contents
