Problem Solving; Reading The Indicators; When The (Warning) Indicator Is Lit Or Flashing; When The (Operation) Indicator Is Lit Or Flashing - Epson dreamio EMP-TW200H User Manual

Problem Solving

Reading the Indicators

The projector is provided with the following two
indicators which notify you of the operating status of
the projector.
The following tables show what the indicators mean and
how to remedy the problems that they indicate.
*If both indicators are switched off, check that the
power cable is connected correctly and that power is
being supplied.
When the
Red
(1-second
intervals)
Red
(0.5-second
intervals)
Red
Orange
When the
When the
Orange
Green
Green
Orange
30
(warning) indicator is lit or flashing
Internal problem / Fan problem / Sensor problem
Disconnect the power cable from the electrical outlet. Then contact your dealer or
the nearest address provided in the "International Warranty Conditions" section of
the Safety Instructions/World-Wide Warranty Terms booklet.
Lamp problem / Lamp on error
Check if the lamp is broken.
Replace the
lamp and
If the lamp is
then turn the
not broken
power on.
If the lamp is
Contact your local dealer for further advice.
broken
High internal temperature
(overheating)
The lamp will switch off
automatically and projection will
stop. Wait for approximately 5
minutes.
High-speed cooling in
progress
You can continue using the
projector, but if the temperature
rises again, it will switch off
automatically.
(operation) indicator is lit or flashing
(warning) indicator is off
Standby
If you press
condition
Warm-up in
Warm-up time is approximately 45 seconds.
progress
Power off operations are ignored while warm-up is in progress.
Projection in
Normal operation is in progress.
progress
Cool-down time is approximately 30 seconds.
Cool-down in
After cool-down is complete, the projector goes to standby mode.
progress
You cannot use the remote control or the projector's control panel during cool-down.
(operation) indicator
warning/problem
p.38
If the problem is still not solved after the lamp is replaced, stop
using the projector and disconnect the power cable from the
electrical outlet. Then contact your dealer or the nearest address
provided in the "International Warranty Conditions" section of the
Safety Instructions/World Wide Warranty Terms booklet.
• When installing
against a wall, leave
a space of 20 cm or
more between the
projector and the
wall.
• Clean the air filters if
they are blocked.
p.36
, projection will start after a brief interval.
(warning) indicator
: Lit
If the problem is not solved
when the power is turned back
on, stop using the projector
and disconnect the power
cable from the electrical
outlet. Then contact your
dealer or the nearest address
provided at "International
Warranty Conditions" in Safety
Instructions/World-Wide
Warranty Terms booklet.
normal
: Lit : Flashing
: Flashing