Table of Contents
Advertisement
When the Indicators Provide No Help
If any of the following problems occur and the indicators do not offer a solution, refer to the pages
given for each problem.
Problems relating to images
No images appear
Projection does not start, the projection area is
completely black, the projection area is completely blue,
etc.
The message "Not Supported." is displayed
The message "No Signal." is displayed
Images are fuzzy or out of focus
Interference or distortion appear in images
Problems such as interference, distortion or black &
white checked patterns appear.
Image is truncated (large) or small
Only part of the image is displayed.
Problems when projection starts
Power does not turn on
Problems relating to images
No images appear
Have you pressed the [Power]
button?
Are all of the indicators
switched off?
Is blank mode active?
Is a video signal being input?
Are the image signal format
settings correct?
Have the configuration menu
settings been made correctly?
Were the projector and
computer connected while their
power was already turned on?
When a computer is
connected
See below
p.32
p.32
p.33
p.33
p.35
Press
on the remote control or
Disconnect the power cable and then reconnect it.
Check the circuit breaker to see if power is being supplied.
Press
on the remote control to cancel the blank function.
Check that the power for the connected equipment is turned on. If the
"Message" menu command has been set to "ON", messages relating to
the image signals will be displayed.
"Setting" - "On-Screen Display" - "Message" p.20
Use the "Video Signal" menu command to select the signal format
which matches the connected signal source.
"Setting" - "Input Signal" - "Video Signal" p.21
Try resetting all of the current settings.
If the connection is made while the power is already turned on, the
function (Fn) key that switches the computer's video signal to external
output may not work. Turn the power for the computer that is connected
to the projector off and then back on again.
Image colours are not right
The whole image appears purplish or
greenish, images are black & white, colours
appear dull, etc.
(Computer monitors and LCD screens have
p.32
different colour reproduction performance,
so that the colours projected by the projector
and the colours appearing on the monitor
may not necessarily match, but this is not a
sign of a problem.)
Images appear dark
Vertical stripes appear in the projected
images
p.34
Projection stops automatically
Problems with the remote control
The remote control does not work
on the projector's control panel.
Problem Solving
p.34
p.34
p.35
p.35
Setup Guide
p.22
31
Advertisement
Table of Contents
