Resetting The Lamp Operating Time - Epson EMP-8300 User Manual

Maintenance Maintenance
TIP
• Install the lamp securely. If the lamp cover is removed, the lamp turns
of automatically as a safety precaution. Moreover, the lamp will not
turn on if the lamp or the lamp cover is not installed correctly.
• Spare lamps are provided with spare air filters. The air filters should
also be replaced when the lamp is replaced.
• Dispose of used lamps properly in accordance with your local
regulations.

Resetting the Lamp Operating Time

The projector has a built-in counter which keeps track of the lamp
operating time, so that when the cumulative operating time reaches a
certain point, it causes the replacement warning message to be displayed.
Therefore, the counter needs to be reset using the configuration menu after
the lamp has been replaced with a new one.
TIP
Do not reset the lamp operating time except after the lamp has been
replaced. If the lamp operating time is reset at any other time, the
lamp replacement period will not be indicated correctly.
PROCEDURE
1
p.136
2
Connect the power cable, turn on the projector's
power, and then press the [Menu] button on the
remote control.
The configuration menu will be displayed.
Remote control
Select "Reset Lamp Timer" from the "About" menu
and then press the [Enter] button on the remote
control or the [Auto/Enter] button on the projector's
control panel.
:
Lamp 1900H
:
Reset Lamp Timer Execute
:
Source Computer1
:
Input Signal Analog-RGB
:
Frequency H ---.--kHz
:
V ---.--Hz
:
SYNC Polarity H ------
: V ------
:
SYNC Mode ------
:
Resolution 0x 0
:
Refresh Rate 0.0 Hz
135