Setting Password Protect; When "User's Logo Protect" Is Enabled (On) - Epson EMP-8300 User Manual

Preventing theft (Password Protect)(EMP-9300 only)

When "User's Logo Protect" is enabled (ON)

If an attempt is made to carry out any of the following user logo
operations, a message is displayed and the setting can not be changed. To
change the setting, set "User's Logo Protect" to "OFF" first.
• Capturing a user's logo
• Changing the setting for the "No-Signal Msg." command in the "Setting"
menu from "Logo" to "Black", "Blue" or "OFF", or when changing it
from "Black", "Blue" or "OFF" to "Logo"
• Changing the setting for the "A/V Mute" command in the "Setting" menu
from "Logo" to "Black" or "Blue", or when changing it from "Black" or
"Blue" to "Logo""
• Changing the "Startup Screen" setting in the "Advanced" menu ("ON" or
"OFF")

Setting Password Protect

Use the following procedure to set Password Protect.
After the Password Protect setting menu has been displayed, the
p.38
subsequent operations are the same as for the configuration menu.
PROCEDURE
Press the [Freeze] button on the remote control for
1
approximately five seconds.
The Password Protect menu will be displayed.
Remote control
TIP
• If Password Protect has already been enabled, the "Password"
screen will be displayed.
If the password has been entered correctly, the "Password Protect"
menu will be displayed.
See "When Password Protect is enabled"
• If Password Protect is set to "ON", attach the accessory Password
Protect sticker to your preferred position on the projector as a
theft-prevention measure.
Password Protect
Power ON Protect : ON OFF
Set
Timer 0H
Timer-el apsed : 0H
ON OFF
User's Logo Protect :
Set
Password
p.36
37