Resetting The Lamp Operating Time - Epson EMP-730 User Manual

Maintenance

Resetting the Lamp Operating Time

The projector has a built-in counter which keeps track of the lamp operating
time. When the cumulative operating time reaches a certain point, it causes the
replacement warning message to be displayed. Therefore, the counter needs to
be reset after the lamp has been replaced with a new one. You can do this using
the projector menu.
Tip :
Do not reset the lamp operating time except after the lamp has been replaced, otherwise
the lamp replacement period will not be indicated correctly.
Procedure
1 Connect the power cord, turn on
the projector's power, and then
press the [Menu] button on the
remote control.
The main menu will be displayed.
2 Select "Reset Lamp Timer" from the
"About" menu and then press the
[Enter] button.
3 Select "Yes" and then press the
[Enter] button.
The lamp operating time will then be
reset.
80
A/V Mute Freeze
Menu
E-Zoom
Enter
Remote Control
Lamp : 1400H
Reset Lamp Timer : Execute
:
Video Source Computer
:
Input Signal RGB
:
Frequency H ---.--kHz
: V ---.--Hz
:
SYNC Polarity H ------
: V ------
SYNC Mode : ------
:
Resolution 0x 0
:
Refresh Rate 0.0 Hz
Reset Lamp Timer
Execute?
YES NO