Epson EMP-8300 User Manual page 118

Problem Solving Problem Solving
Status
Fan related error/Sensor error
Red
Red
Lamp cover is open error./
Red
Lamp timer failure/
Red
Lamp out
Internal temperature error
Red
(overheating)
Red
High-speed cooling in progress
Red
Orange
Cause
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your
dealer or the nearest address provided in the "International Warranty Conditions" section of the
Safety Instructions/World-Wide Warranty Terms booklet.
Take out the lamp and check if it is broken. Replacing the Lamp
If the lamp is not broken, put it back in and then turn the power on. If the lamp still does not turn
on, replace it with a new lamp.
If this does not solve the problem, stop using the projector and disconnect the power cable from
the electrical outlet. Then contact your dealer or the nearest address provided in the "International
Warranty Conditions" section of the Safety Instructions/World-Wide Warranty Terms booklet.
If the lamp is broken replace by a new lamp, or contact your local dealer for further advise.
(Projection cannot be carried out until the lamp is replaced.)
Check that the lamp and the lamp cover are securely installed. If the lamp or lamp cover is not
securely installed, the lamp will not switch on.
The lamp will turn off automatically and projection will stop. Wait for about 5 minutes without
operating the projector.
The EMP-9300 will switch to standby mode after about 5 minutes, so check the following two
points. After checking, press the [Power] button to turn the power back on.
With the EMP-8300 after about 5 minutes have elapsed, disconnect the power plug and check the
following two points. After checking, reinsert the power plug and press the [Power] button to turn
the power back on.
•Check that the air filter and air exhaust vent are clear, and that the projector is not positioned
against a wall.
•If the air filters are blocked, clean or replace them.
If the projector continues to overheat even after the above points have been checked, or if the
indicators show a problem when the power is turned back on, stop using the projector, disconnect
the power cable from the wall outlet and contact the nearest address provided at "International
Warranty Conditions" section of the Safety Instructions/World-Wide Warranty Terms booklet.
(This is not an abnormality, However, if the temperature rises too high again, projection will stop
automatically.)
•Check that the air filters and air exhaust vent are clear and that they are not up against a surface
such as a wall.
•If the air filters are blocked, clean or replace them.
Remedy or Status
p.17
p.17
: lit : flashing
p.133
p.130
p.130
117
: off