Epson EMP-760 User Manual page 97

Problems Solving
Check
Cannot find a projector of the specified
addressg.
Image transfer slows if PC resolution is higher
than XGA (1024 × 768 pxl.) Do you want to
continue?
For Windows
Image transfer slows if screen color is more
than 24 bits. NS Connection converts it to 16
bits. Do you want to continue?
For Windows
If an error message not described above is displayed, refer to the EMP NS Connection help.
Error messages from EMP SlideMaker2
Check
**.SIT already registered.
(** is the scenario file name.)
Not enough disk space.
IP
Check that "Wired LAN connection mode" or "Access Point Mode (Wireless LAN)" setting is being
used in the EasyMP configuration settings for the projector to be connected. In the wireless LAN
setting screen, change to "Access Point Mode" if it is set to "Easy Connect Mode".
Next, check the "IP Address" setting in the "Wired LAN" - "Basic" or the "Wireless LAN" - "Basic"
configuration menu, and specify that IP address when connecting in IP connection mode.
Connected Projectors Appear" in the EasyMP Operation Guide.
If connection is still not possible, check the network settings at the computer and the EasyMP
network settings at the projector.
For details on network setting: s"Connecting in Access Point Mode or Wired LAN Mode" in the
EasyMP Network Setup Guide
The display of the computer being connected to the projector is set to resolution higher than XGA
(1024 × 768).
Clicking "Yes" connects the projector. However, the display speed of the projection screen will be
slow.
Clicking "No" aborts the projector connection. To avoid slow display speeds on the projection
screen, change the computer display settings to: XGA (1024 × 768) or lower.
The display of the computer being connected to the projector is set to a resolution of higher than
XGA (1024 × 768), or the screen colour has been set to 24 bits or more.
Clicking "Yes" connects the projector. However, the display will be in 16 bit colour.
It is not possible to add a scenario file name if it already exists in the "Autorun Scenario List".
s"Sending a
Scenario" in the EasyMP Operation Guide
The drive to which a scenario is being sent has insufficient free space and the scenario cannot be
sent. Delete unneeded files on the destination drive to free sufficient disk space to save the scenario
on the drive.
Remedy
Remedy
User's Guide
96
s"If No