Epson EMP-760 User Manual page 38

Turning the Projector On
If more than one external device is connected to the
4
projector, use the remote control or projector control
panel buttons to select the image source to be
projected while referring to the following table.
The input source can also be searched for and
projected automatically each time the [Source
Search] button is pressed.
Remote control
Remote control
Source
button selected
Computer/
Computer
Component Video
S-Video S-Video
Video Video
*2
EasyMP
EasyMP
*1 Displays the selected source as the "Computer Input" - "Signal" in the
configuration menu.
*2 Only changes when using the EMP-765.
sEasyMP Operation Guide
for details on using EasyMP.
Projector
Display at top-right of screen
*1
Computer (Auto)
*1
Computer
*1
Component Video
S-Video
Video
EasyMP
and the EasyMP Network Setup Guide
TIP
TIP
• If only one signal source has been connected, the signals from that
source will be projected without the need to press any of the buttons
on the remote control or the projector's control panel.
• If using an EMP-765, EasyMP is detected as a source by pressing
the [Source Search] button only when the CardPlayer is running
with an inserted memory card or connected USB equipment, or when
a LAN card is inserted. When EasyMP is not displayed by the
[Source Search] button, press the [EasyMP] button on the remote
control to switch the projected image to EasyMP.
• If the "No Signal." message does not disappear, check the
connections again.
• If a laptop computer or a computer with an LCD screen has been
connected to the projector, the images may not be projected straight
away. After starting projection, check that the computer has been set
up to output signals externally.
The following table shows examples of how to toggle output settings.
For details, refer to the section of the documentation provided with
your computer under a heading such as "External output",
"Connecting an external monitor" or similar.
NEC Panasonic Toshiba IBM
[Fn]+[F3] [Fn]+[F3] [Fn]+[F5] [Fn]+[F7] [Fn]+[F7] [Fn]+[F10]
• If the same still picture is projected for a long period of time, the
projected image may become burned into the screen. You should
avoid leaving the same image displayed for long periods.
User's Guide
Sony Fujitsu Macintosh
Set mirror setting or
display detection.
37