Epson EMP-760 User Manual page 95

Problems Solving
An error message is displayed
Error messages from EMP NS Connection
Check
Failed to connect to a projector.
Network settings are being made
automatically.
Projector detection error.
No connectable projector exists, or the
projector's power is not turned on.
Incorrect keyword. Enter the keyword
displayed on the projector.
Select a connecting projector from the list.
The selected projector is in use. Continue to
connect?
Failed to initialize EMP NS Connection.
Try to reconnect. If connection is still not possible, check the network settings at the computer and at
the projector.
For details on EasyMP network settings: sEasyMP Network Setup Guide
If the computer has been set to use DHCPg, it may take some time for the
the IP address has not been determined within about 70 seconds after the message is displayed, an
error message will be displayed. If this happens, try closing EMP NS Connection and then restarting
it.
Carry out the following.
• Turn the power on for the projector, complete the projector preparation and then click the "Search
Again" button.
• Check the projector's configuration setting for EasyMP.
• Check the security software settings for the computer, and cancel the port settings if the ports have
been limited.
Check the keyword for the projector that is displayed in the EasyMP standby window, and enter that
projector's keyword.
Select the name of each projector for the connection, and click the "Connect" button.
sEasyMP Network Setup Guide
You are attempting to connect to a projector already connected to another computer.
Click "Yes" to connect to the projector. The connection between the projector and the other
computer will be terminated.
Click "No" to end the connection attempt to the projector. The connection to the other computer will
not be affected.
Uninstall and then reinstall EMP NS Connection.
s"If You would like to Uninstall the EasyMP Software" and "Installing EasyMP Software" in the
EasyMP Network Setup Guide
Remedy
IP addressg
User's Guide
94
to be set. If