Connecting S-Video Or Component Video - Epson PowerLite 8200i User Manual

Connecting S-Video or Component Video

Before starting, make sure the projector and your VCR or other video
source are turned off.
1. For S-Video, insert one end of an S-Video cable into the
projector's
S-Video
S-video-out port of your video source.
S-Video
connector
For component video, connect the three ends of a BNC cable into
the projector's ,
R G
projector's
H/C Sync
the cable into the corresponding ports of your video source. If the
image doesn't display properly, you may need to change the BNC
parameter in the projector's Setting menu. See page 69.
2. If you'll be using audio, connect the RCA audio cable to the
and
S-Audio Audio2
the other end of the cable to the audio output ports of the video
source.
connector. Insert the other end into the
, and ports. (Don't connect the cables to the
B
or ports.) Insert the opposite ends of
VSync
ports of the projector. Connect the plugs at
S-Video cable
note
Contact your video
manufacturer or other video
or electronics dealer to obtain
a component video cable.
Setting Up the Projector
37