Problems With The Image Or Sound - Epson PowerLite 8200i User Manual

Problems with the Image or Sound

No image appears on the screen.
Check that the power light is green, not flashing, and the lens
I
cover is off.
The projector may be in sleep mode. If the power light is orange,
I
press the button to turn the projector on.
Power
If the power was switched off and then on again, the projector
I
may still be cooling down. Wait until the power light stops
flashing and remains orange; then press the
I Make sure the
Brightness
See page 64 for more information. Try selecting the
setting to return all setup menus to their default values.
Press the
I A/V Mute
turned off temporarily.
The attached computer may be in sleep mode or displaying a
I
black screen saver. Try pressing a key on the computer.
You see a blue screen with the message No Signal
displayed.
I Make sure the cables are connected correctly, as described in
Chapter 1.
I Try restarting your computer.
If you've connected more than one computer and/or video source,
I
you may need to press the
control panel) or the
(on the remote control) to select the correct source. Allow a few
seconds for the projector to sync up after pressing the button.
If you've connected a second computer or you're using
I
component video, make sure the
is correct. See page 69 for more information.
Make sure the
I
Computer 1/DVI
interface panel is set correctly. See Chapter 1.
setting on the Video menu is correct.
button to make sure the picture has not been
or
Computer Video
,
Comp1 Comp2/YCbCr
option in the Setting menu
BNC
selector switch on the projector's
button again.
Power
Reset All
button (on the
, or button
Video
Solving Problems
87