Epson PowerLite 8200i User Manual page 27

Connecting the Video Cable
1. Connect one end of the computer video cable to the projector's
(VGA) port.
Computer 1
Computer 1 (VGA) port
2. Make sure the DVI/VGA
switch on the back panel is
flipped to the right, as shown.
If necessary, use the tip of a
ballpoint pen to slide it over.
3. Connect the other end of the
video cable to the laptop's video (monitor) port.
4. Tighten the screws on the connectors.
If you don't need to make any other connections, you can plug in
your projector and turn it on. See page 39 for instructions.
computer video cable
DVI/VGA switch (slide to right)
Computer 1
Computer 2 /
Component Video
R/Cr/Pr G/Y B/Cb/Pb H/C Sync V Sync
Setting Up the Projector
21