Making Other Computer Connections - Epson PowerLite 8200i User Manual

Making Other Computer Connections

If you want to connect a computer using the BNC cable or connect a
high-end workstation or a Digital Visual Interface (DVI) source,
follow the instructions below.
Connecting a Computer Using the BNC Cable
Follow these steps to connect a computer to the
interface using the BNC cable:
Component Video
1. Connect the VGA (D-sub 15-pin) end of the cable to your
computer's video port.
2. Connect the five connectors at the other end of the cable to the
projector's
R/Cr/Pr
(horizontal sync), and
Computer 1
Computer 2 / Component Video
R/Cr/Pr G/Y B/Cb/Pb
Remote
Mouse/Com
3. To display images properly, make sure the BNC parameter in the
projector's Setting menu is set to
4. If you want to hear computer-audio through the projector, you'll
need an RCA-to-3.5 mm stereo cable (available for purchase from
your electronics store or video dealer). Insert the cable's 3.5-mm
plug into your computer's audio-out port. Then attach the RCA
connectors at the other end of the cable to the
ports of the projector.
Audio2
(red), (green),
G/Y B/Cb/Pb
(vertical sync) ports, shown below.
VSync
H/C Sync V Sync
Audio
. See page 69.
RGB
Computer 2/
(blue),
H/C Sync
BNC connectors
and
S-Audio
Setting Up the Projector
33