Attaching Handwheel - Craftsman 113.198111 Operator's Manual

6. Put another hex nut on each of the leveling
,feet and hand-tighten until they are against
the leg.
Leg
10. Adjust the lower nut with the 9/16 inch
wrench until the leveling jbot is at the desired
height.
11. Tighten the top nut by hand.
12. Repeat steps 8-11 for the other three lev-
eling feet if necessary.
13. Tighten all four bottom nuts using a 9/16
inch wrench.
Fig. 15
Nuts
Leveling Foot
Attaching Handwheel
1. Place the handwheel on the front of the
saw. The front of the saw has a D-shaft that
fits into a D-slot in the handwheel.
_lb WARNING: Saw blade can roll for-
ward toward you if the leveling feet are
not correctly adjusted. Workpiece or
saw can move unexpectedly if cabinet
rocks. Fingers, hand, or arm can be cut
off from blade contact. Adjust leveling
feet before using your saw.
7. If the leveling feet raise the front of the
saw slightly higher than the rear, and if the
leg set does not rock, go to step 13, or
If the leveling feet do not raise the front of the
saw slightly higher than the rear, go to step 8,
or
2. Attach the handwheet using a screw and
external lockwasher. (Figures 16 & 17 )
Handwheel
If the leg set rocks, go to step 8.
8. Loosen the bottom hex nut on the desired
leveling foot using a 9/16 inch wrench.
9. Loosen the top nut by hand.
Fig. 16
©
Fig. 17 - Screw and External Lockwasher
10