Installing And Adjusting Rip Scale Indicators - Craftsman 113.198111 Operator's Manual

Installing and Adjusting Rip Scale Indica-
tors
NOTE: The rip scales indicators are intended
to be used for quick settings. Adjustments
will be necessary for blades of different thick-
nesses. For greater accuracy take direct mea-
surements between blade and fence with ruler
or measuring tape.
1. Locate rip scale indicators in a loose parts
bag and slide indicators onto mounting brack-
ets.
2. Unlock the swivel lock and move the
blade into the OUT-RIP position. Lock the
swivel lock.
Inches
Fig. 78- Out-Rip Saw Position (Infeed End)
3. Measures 2" from rip fence to nearest
tooth on the blade and lock rip lock handle.'
4. Adjust "out rip" scale indicator by slid-
ing until indicator line reads 2 inches on the
upper of the two "out rip" scales as illus-
trated. Out rip scales are located on left side
of arm.
5. Unlock rip lock and move blade away
from fence. Unlock the swivel lock and rotate
the motor to the IN-RIP position. Lock the
swivel lock. Push the motor until the blade
rests against the fence.
6. Adjust "in-rip" scale indicator (located
on right side of arm) by sliding until indicator
line reads "0" inches.
33