Installing The Handwheel Handle; Installing The Rear Outfeed Support; Power Cord - Craftsman 137.415030 Operator's Manual

Fig. J
Power cord (Fig. J-1)
Wrap the power cord (1) as shown. Do
not wrap the power cord around the
dust port (2).
Fig. J-1
2
1
INSTALLING THE HANDWHEEL
HANDLE (FIG. K)
NOTE: UP-DOWN is printed on this
handwheel.
1. Thread the handwheel handle (1)
into the handwheel hole (2), and
then tighten.
Fig. K
2
3
1
2
1
INSTALLING THE REAR OUTFEED
SUPPORT (FIG. L, M)
1. Insert the two rear outfeed support
tubes (2) into the rear outfeed
support (1). (Fig. L)
NOTE: They must be inserted into
the back of the extension with the
dimple end so that the bar will hold
the extension in place.
2. Snap two black plastic stops (3)
over the two rear outfeed support
tubes (2). Make sure the locating
pin in the black plastic stops fits into
the matching hole in the support
tube. This will "lock" the tube into
the support. (Fig. L)
NOTE: The plastic stops (3) must
be installed underneath the rear
outfeed support tubes (2).
Fig. L
3. Insert the rear outfeed support
tubes (2) into the two holes in the
rear of the saw table, and into the
support tube brackets under the
table. Position the rear outfeed
support so that the instruction labels
are facing up. (Fig. M)
4. Tighten one rear outfeed support
stop screw (4) on the end of the
left rear outfeed support tubes (2).
Verify that the screw is fully inserted
into the corresponding hole in the
support tube. (Fig. M)
23 23
dimple end
1
3
2