Maintenance - Jenn-Air JER8885RAB Use & Care Manual

Electric range
Hide thumbs Also See for JER8885RAB:
Table of Contents

Advertisement

Available languages

Available languages

M
AINTENANCE
Oven Door
CAUTION
Do not place excessive weight on or stand on an open
oven door. This could cause the range to tip over, break
the door, or injure the user.
Important: The oven door on a new range may feel "spongy"
when it is closed. This is normal and will decrease with use.
Oven Window
To protect the oven door window:
1. Do not use abrasive cleaning agents such as steel wool
scouring pads or powdered cleansers as they may scratch
the glass.
2. Do not hit the glass with pots, pans, furniture, toys, or
other objects.
3. Do not close the oven door until the oven racks are in
place.
Scratching, hitting, jarring or stressing the glass may weaken
its structure causing an increased risk of breakage at a later
date.
Leveling Legs
CAUTION
Be sure the anti-tip bracket secures one of the rear
leveling legs to the floor. This bracket prevents the range
from accidentally tipping.
Be sure the range is leveled when installed.
If the range is not level, turn the leveling legs,
located at each corner of the range, until range
is level.
Oven Light
• Disconnect power to range before replacing light bulb.
• Use a dry potholder to prevent possible harm to hands
• Be sure bulb is cool before touching bulb.
• Do not touch hot bulb with a damp cloth as this may cause
To Replace Oven Light Bulb:
1. When oven is cool, hold bulb cover in place, then slide wire
2. Remove bulb cover and light bulb.
3. Replace with a 40-watt appli-
4. Replace bulb cover and se-
5. Reconnect power to range. Reset clock.
Convenience Outlet
(Canadian models only)
The convenience outlet is located
on the lower left side of the
backguard. Be sure appliance cords
do not rest on or near the surface
element. If the surface element is
turned on, the cord and outlet will
be damaged.
The convenience outlet circuit
breaker may trip if the small
appliance plugged into it exceeds
10 amps. To reset the circuit
breaker, press the switch located
on the lower edge of the
backguard.
ANTI-TIP BRACKET
ANTI-TIP BRACKET
LEVELING LEG
LEVELING LEG
7
CAUTION
when replacing bulb.
the bulb to break.
retainer off cover. NOTE: Bulb cover will fall if not held in place
while removing wire retainer.
ance bulb.
cure with wire retainer.
BULB COVER
WIRE
RETAINER
CIRCUIT BREAKER

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Jer8885ras

Table of Contents