Using Dolby Prologic Ii, Dolby Digital And Dts Digital Surround - JVC RX-5022VSL Instructions Manual

Before you start, remember...
° Make sure that you have set the speaker information correctly (see pages 12 to 14).
• You cannot adjust the center speaker output level when you have set "CNTR SP" to "NONE."
• You cannot adjust the rear speaker output levels when you have set "REAR SP" to "NONE."
• Remember not to change the speaker setting while using any Surround modes; otherwise, it may be canceled when you deactivate the
speakers required for the Surround mode.
/
g
g_
tt_
¢D
a_.
Eo
o
cg
s
L
Ee
L
Once you have adjusted the sound, the adjustment is memorized for
each source.
° When playing back digital multichannel software (Dolby Digital
5.1 ch or DTS Digital Surround), the SURROUND MODE button
does not work.
Fromthe remote control:
It will be convenient for you to use the remote control for
adjustments, since you can make adjustments from your listening
point by using the test signal.
° For selecting Panorama control for Pro Logic II Music, use the
buttons on the front panel.
1 Setting the analog or digital input mode for the
source you like to listen and start playing.
When playing back software encoded with Dolby Digital and
DTS Digital Surround, select the digital input mode (see page
11).
2 Press SURROUND ON/OFF to
000o00
activate Surround mode. s
Each time you press the button, Surround mode
turns on and off alternately.
• If you are playing back software encoded with Dolby Digital
multichannel, "DOLBY DIGITAL" is selected.
• If you are playing back software encoded with DTS Digital
Surround, "DTS SURROUND" is selected.
• If you are playing back any software other SURROUND
than above, you can select "PL II MUSIC" or _..rcx
"PL II MOVIE" according to the source by
Z)
pressing SURROUND MODE. (l']['l PRO
LOGIC II indicator lights up on the display.)
If you like to adjust sound, go to step ;3.
TO BE CONTINUED TO THE NEXT PAGE
21