Table of Contents
Advertisement
You can use the remote control to operate other JVC's
components.
IMPORTANT:
To operate JVC's audio components
using this remote control:
• You need to connect JVC's audio components through the COMPU
LINK (SYNCHRO) jacks (see page 24) in addition to the
connections
using cables with RCA pin plugs (see page 6).
• Aim the remote control directly at the remote sensor on the receiver.
• If you use the buttons on the front panel, the remote control will not
operate that source. To operate a source with the remote control,
the source must be selected using source selecting buttons on the
remote control.
• To operate the cassette deck or CD recorder using the COMPU
LINK remote control system, set the source name correctly. (See
page 8.)
• Refer also to the manuals supplied with your audio components.
Sound Adjustment
You can always perform the following operations:
SURROUND
MODE
: Select
the Surround
modes.
After pressing
SOUND,
you can use the following
buttons
for sound
adjustment:
CENTER
+/-
: Adjust
the center
speaker
output
level.
REAR*R
+/-
: Adjust
the right rear speaker
output
level.
TEST
: Turn
on or off the test tone output.
Note:
After adjusting sounds, press the corresponding
source selecting
button or CD-DlSC to operate your target source by using the 10
keys; otherwise, the 10 keys cannot be used for operating your target
source.
Tuner
You can always perform the following operations:
FM MODE
: Change the FM reception mode.
After pressing
FM/AM,
you can use the following
buttons
for tuner
operations:
/
O
3=
"u
ip,.=
m
Z
¢D
o
o
=
O
Ill
C=
L
mo
o
mo
L
¢D
o
o
"o
o
After pressing
CD, you can use the following
buttons
for CD
operations:
1<4
: Return
to the beginning
of the current
(or previous)
track.
•
: Stop playback.
1 - 10, +10
: Select
a track number
directly.
• For track number
5, press
5.
• For track number
15, press
+10, then 5.
• For track number
20, press
+10, then
10.
25
Hide quick links:
Advertisement
Table of Contents
