Table of Contents
Advertisement
Basic Operations
Front
Panel
n_
[.m [_,"L_I I_
Press STANDBY/ON
©/I (or STANDBY/ON
©/I AUDIO
on the
remote
control).
STANDBY/ON
........
OD/I
%
On the front panel
From the remote control
The STANDBY
lamp goes off. The name of the current
source (or
station frequency)
appears
on the display.
Current
source
name appears
_"ra
TI
I I
ll
II
II
JJ
Current
volume
level is shown
here
To turn off the power (into
standby
mode)
Press STANDBY/ON
0/I
(or
STANDBY/ON
Oil AUDIO
on the remote
control) again.
The STANDBY
lamp on the front panel lights up.
STANDBY/O_/_
Note:
A small amount of power is consumed in standby mode. To turn the
power off completely,
unplug the AC power cord.
Press one of the source selecting
buttons.
The selected
source name
appears
on the display.
DVD
VCR
TVSOUND
I/
II
II
/I
CD
TAPFJCDR
FM/AM
I[
II
II
jl
On the front panel
TAPE/CDR
CD
DVD
FM/AM
TV SOUND
VCR
From the remote control
DVD
VCR
TV SOUND
CD *
TAPE/CDR *
FM/AM *
Notes:
Select the DVD player.
Select the VCR.
Select the TV sound (or the CATV converter).
Select the CD player.
Select the cassette
deck (or the CD recorder).
Select an FM or AM broadcast.
° Each time you press the button,
the band
alternates
between
FM and AM.
• When connecting a CD recorder (to the TAPE/CDRjacks),
change
the source name that appears on the display, See below for details.
• When you have connected some digital source components
using
the digital terminals (see page 7), you need to select the digital
input mode (see page 11).
• When you press one of the source selecting buttons on the remote
control marked above with an asterisk (*), the receiver
automatically
turns on.
Changing
the source name
When you connect
the CD recorder
to the TAPE/
CDR jacks
on the rear panel and select the CD
recorder
as the source,
change the source name
shown on the display.
Press TAPE/CDR (SOURCE NAME).
° Make sure "TAPE" appears on the display.
2
Press and hold SOURCE
NAME
(TAPE/CDR)
until "ASSIGN
CDR"
appears
on the display.
To change
the source
name from "CDR"
to "TAPE"
repeat the
same procedure above (in step
I, make sure "CDR"
appears on the
display).
Note:
Without changing the source name, you can still use the connected
component.
However, there may be some inconvenience.
- "TAPE" will appear on the display when you select the CD
recorder.
- You cannot use the digital input (see page 11) for the CD recorder.
- You cannot use the COMPU LINK remote control system (see page
24) to operate the CD recorder.
8
Hide quick links:
Advertisement
Table of Contents
