Digital Connections; Connecting The Power Cord - JVC RX-5022VSL Instructions Manual

[ VCR ] IMPORTANT:
,®
CD
OUT
(REC)
TAPE
TV SOUND_
DVD
OU
VCR
(PLAY)
To left/right channel audio output
[_ To left/right channel audio input
[_ To video output
[_ To video input
I DVDplayer ]
r
_[ DVD player
OUT
(REC)
To front left/right channel audio output (or to audio mixed
output)
[_ To video output
Note:
To enjoy the software encoded with Dolby Digital or DTS Digital
Surround, you must connect the DVD player using the digital terminal
on the rear of this receiver. (See "Digital connections" below.)
Digital connections
This receiver is equipped with two DIGITAL IN terminals--one
digital coaxial terminal and one digital optical terminal.
You can connect any component to one of the digital terminals using
a digital coaxial cable (not supplied) or digital optical cable (not
supplied).
• When connecting the DVD player or digital TV using the digital
terminal, you also need to connect it to the video jack on the rear.
Without connecting it to the video jack, you can view no playback
picture.
• After connecting the components using the DIGITAL IN terminals,
set the followings correctly if necessary:
- Set the digital input (DIGITAL IN) terminal setting correctly. For
details, see "Setting the Digital Input (DIGITAL IN) Terminals" on
page 11.
- Select the digital input mode correctly. For details, see "Selecting
the Analog or Digital Input Mode" on page 11.
Digital TV
DVD player
.m
CD player
i_ .i
CD recorder
_ m--mmmmm
_ _=%-_=-_=-=
m
F
When the component has a digital (
coaxial output terminal, connect it to the)
DIGITAL 1 (DVD) terminal, using the
digital coaxial cable (not supplied).
When the component has a digital
optical output terminal, connect it to the
DIGITAL 2 (CD) terminal, using the
digital optical cable (not supplied).
Before connecting a digital
optical cable, unplug the
protective plug.
DIGITAL 1
D)
DIGITAL 2 ( CD )
DIGITAL IN --
Notes:
• When shipped from the factorJ4 the DIGITAL IN terminals have
been set for use with the following components.
- DIGITAL 1 (coaxial): For DVD player
- DIGITAL 2 (optical): For CD player
• When you want to operate the CD player or CD recorder using the
COMPU LINK remote control system, connect the target
component also as described in "Analog connections" (see page 6).
Before plugging the power cord into an AC outlet, make sure that all
connections have been made.
Plug the power cord into an AC outlet.
CAUTIONS:
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord. When
unplugging the cord, always grasp the plug so as not to damage
the cord.
/
G_
ee_
L
7