Double Scrub; Emptying And Cleaning Tanks; Solution Tank - Windsor Saber Cutter SCX264 Operating Instructions Manual

Operations

Double Scrub

For floors which are heavily soiled or have thick accu-
mulations of floor finish may not clean sufficiently with
one pass. In these cases it will be necessary to double
scrub.
To double scrub, make the first pass over the surface
being cleaned with the squeegee up, vacuum off, the
solution on, Aqua-Mizer removed and brushes down.
This allows the solution to stay in contact with the soil
while loosening the surface accumulation with the
brushes. Allow time for the first application to stay in
contact with the floor. Length of time between the first
and second pass depends on amount of accumulation
and the type of chemical being used. A second
scrubbing with the squeegee down and again the
solution and brushes on will further loosen soil. The
additional application of solution will further assist the
difficult cleaning job.
FOR SAFETY: When using machine, go slow on
inclines and slippery services.

Emptying And Cleaning Tanks

1. Park the machine next to a floor drain. Drain hose
is on left rear corner of the machine.
2. Turn the machine power off and set parking brake,
if your machine is equipped with this option.

Solution Tank

1. Loosen small drain hose from the retainer, then
lower hose in direction of the drain.
2. Remove the solution tank cover.
3. Flush the solution tank out with clean water and
run several gallons of clean water through
systems. Do not use water hotter than 140°F
(60°C) to clean tank. Damage may occur.
NOTE: Never allow solution to remain in tank.
Damage to tank, seals and valves could occur.
4. Secure drain hose into the retainer.
20
Recovery Tank
1. Unhook the large drain hose from the retainer.
2. Remove the recovery tank dome. Flush the
3. Clean off the float shut-off system and inspect for
4. Replace the drain plug and secure drain hose in
5. If machine is to be stored, leave the recovery tank
SOLUTION
TANK COVER
86400260 Manual Operators - Cutter 24V Deluxe
Unscrew the T-handle on plug enough to loosen
plug, then lower hose in direction of the drain. Do
not stand in front of end of hose. Recovered
solution will come out with force. Slowly remove
plug from drain hose.
recovery tank out with clean water. Do not use
water hotter than 140°F (60°C) to clean tank.
Damage may occur.
free movement of float. The float shut-off system is
located in the rear of the recovery tank.
bracket.
dome off.
RECOVERY
TANK COVER
SOLUTION
TANK DRAIN
RECOVERY
TANK DRAIN