Hardware Configuration; Host Interface; Engine Interface - Kyocera Vi7360 Instruction Handbook Manual

Hardware Configuration

Basic Configuration
Configuration of the Printing System (1) + PS-1 is as follows:
Architecture: IBM Compatible PC System
Processor: Intel Pentium III 500 Mhz
Memory: 64 MB standard / 512 MB max.
Hard Drive: IDE compatible 2.0 GB min.
Floppy Drive: 3.5" Floppy Disk

Host Interface

Parallel
Centronics (IEEE 1284) / compatible bi-directional
Ethernet (option)
100BaseTX and 10BaseT
The optional NC-5 card is used to connect to the Ethernet. The NC-5 is the internal
network interface card which supports multiple protocols on the Ethernet. This card
includes a CPU and flash memory with an upgradable program.
The NC-5 supports the following network protocols.
IPX/SPX (NetWare, Peer to Peer)
TCP/IP (LPD/LPR, Peer to Peer)
Refer to the corresponding operating manual for connection to the NC-5.

Engine Interface

IEEE 1394 (The maximum transferring rate is 200Mbps.)
Use this Engine Interface only to connect the Printing System (1) and the
Vi7360. Otherwise, system trouble may occur.
PS-1 (Printing System (1) PostScript option) 1-5
Chapter 1 Overview