Vulcan-Hart EG160 Service Manual page 13

PILOT LIGHTING AND ADJUSTMENTS (Cont.)
OPEN TOP BURNERS
1. Turn main gas supply "ON".
2. Wait 30 seconds and, using a taper, light the open top pilot (Fig. 10).
Fig. 10
3. If pilot fails to light, turn main gas supply "OFF". Wait 5 minutes and repeat the above procedures.
4. Turn one open top burner valve "ON" to remove air from the gas line. Turn burner "OFF" when gas begins to flow.
OPEN TOP BURNER ADJUSTMENTS
TOOLS REQUIRED: Standard flat blade screwdriver.
1. After pilot is lit, turn open top burners "ON".
2. Adjust the burner flame, if necessary, by rotating the adjustment screw of the pilot valve located on the manifold pipe
(see Fig. 3). Rotate the screw clockwise to decrease and counterclockwise to increase the flame.
Nightly Shutdown: Turn burner valve "OFF"; pilot will remain lit.
Complete Shutdown
1. Turn burner valve "OFF"; pilot will remain lit.
2. Turn main gas supply "OFF".
– 14 –