File Separation - Kyocera TASKalfa 420i Operation Manual

Use the procedure below to select the file format for transmission.
Ready to send.
Place original.
File Format
Image Quality
PDF
TIFF
Place original.
Compression
Ratio Priority
JPEG
XPS
Original : ---
Zoom : 100%
Paper : ---
High Comp.
PDF
Preview
Add Shortcut
Status

File Separation

Create several files by dividing scanned original data page by page, and send the files.
Use the procedure below to split scanned original data into separate files when sending scanned originals.
Ready to send.
Place original.

File Separation

Create and send a file for each page
of the original that was read.
Place original.
Original : ---
Off
Zoom : 100%
Paper : ---
Preview
Add Shortcut
Status
OPERATION GUIDE
1
2
3
4
Destination
Standard Quality
Priority
5
Off
Encryption
Cancel OK
08/08/2009 10:10
6
1
2
3
4
Destination
5
6
Each Page
NOTE:
abc_001.pdf, abc_002.pdf... is attached to the end of
the file name.
Cancel OK
08/08/2009 10:10
Press the Send key.
Place the originals on the platen.
Press [Original/Sending Data Format] and then
[File Format].
Select the file format from [PDF], [TIFF], [JPEG],
[XPS], and [High Comp. PDF].
When the color mode in scanning has been
selected for Grayscale or Full Color, set the image
quality.
If you selected [PDF] or [High Comp. PDF], press
[Encryption] and specify the encryption settings.
Press [OK].
Specify the destination, and press the Start key to
start sending.
Press the Send key.
Place the originals on the platen.
Press [Original/Sending Data Format] and then
[File Separation].
Press [Each Page] to set File Separation.
Press [OK].
Specify the destination, and press the Start key.
The scanned original is sent after being divided into
files of one page each.
Three-digit serial number such as
Sending Functions
5
5-13