Kyocera TASKalfa 250ci Operation Manual page 362

Default Setting (System Menu)
IPSec Setting
Sets up IPSec. The default setting is Off. Use the procedure below.
LAN Interface Setup
Specify the settings for the LAN interface to be used. The default setting is Auto. Use the procedure below.
System - LAN Interface
Select the LAN Interface type.
Auto 10BASE-T 10BASE-T
Half Full
Status
8-98
100BASE-TX 100BASE-TX
Half Full
Cancel OK
10/10/2008 10:10
5
After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
1
Press the System Menu key.
2
Press [System], [Next] of Network Security, and
then [Change] of IPSec.
NOTE:
If user login administration is disabled, the
user authentication screen appears. Enter your login
user name and password and then press [Login]. For
this, you need to login with administrator privileges.
Refer to Adding a User on page 11-4 for the default
login user name and password.
3
Press [On].
4
Press [OK].
5
After changing the setting, restart the system or
turn the machine OFF and then ON again.
For detailed information on restarting the system,
refer to Restarting the System on page 8-88.
1
Press the System Menu key.
2
Press [System], [Next] of Network and then
[Change] of LAN Interface.
3
Select [Auto], [10BASE-T Half], [10BASE-T Full],
[100BASE-TX Half] or [100BASE-TX Full] as the
LAN interface.
OPERATION GUIDE