Installation Precautions - Kyocera TASKalfa 250ci Operation Manual

Installation Precautions

Environment
CAUTION
Avoid placing the machine on or in locations which are unstable or not level. Such locations may cause
the machine fall down or fall over. This type of situation presents a danger of personal injury or damage
to the machine.
Avoid locations with humidity or dust and dirt. If dust or dirt become attached to the power plug, clean
the plug to avoid the danger of fire or electrical shock.
Avoid locations near radiators, heaters or other heat sources, or locations near flammable items to
avoid the danger of fire.
To keep the machine cool and facilitate changing of parts and maintenance, allow access space as
shown below. Leave adequate space, especially around the rear cover, to allow air to be properly
ventilated out of the machine.
Other precautions
The service environmental conditions are as follows:
• Temperature: 50 to 90.5 °F (10 to 32.5 °C), but humidity should be 70% or less when temperature is 90.5
°F (32.5 °C)
• Humidity: 15 to 80 %, but temperature should be 86 °F or less (30 °C or less) when humidity is 80%
However, adverse environmental conditions may affect the image quality. It is recommended to use the machine
at a temperature: around 60.8 to 80.6 °F or less (16 to 27 °C), humidity: around 36 to 65%. In addition, Avoid
the following locations when selecting a site for the machine.
• The machine automatically detects and displays the following message when the environmental
temperature is too high or too low.
x
11 "
13/16
30 cm
3 "
15/16
10 cm
11 "
13/16
30 cm
39 "
3/8
100 cm
OPERATION GUIDE