Ykfcstat Command - HP StorageWorks P9000 Reference Manual

44 - (5 + PREFIX-length)
NOTE:
The execution of this command does not check if the configuration of the copy groups specified
in the copy group definition file is supported. Therefore, an error could result when you specify,
by using the YKIMPORT command, a CSV file created by this command. If an error occurs,
check if the configuration of the copy groups in the CSV file is supported.
The pair information CSV file is created even if an error occurs during creation of the EXCTG
information CSV file.
Return Codes
Table 1 14 (page 214)
Table 1 14 YKEXPORT Command Return Code List
Return Code
0
4
32
40
48
64

YKFCSTAT Command

Applies to Continuous Access Synchronous for Mainframe, Continuous Access Synchronous for
Mainframe with the HyperSwap attribute, Continuous Access Asynchronous for Mainframe, and
Continuous Access Journal for Mainframe.
Format
YKFCSTAT
STEM(stem-name-1)
1
MSG(stem-name-2)
1
DEVN(device-number)
1
Function
This is a TSO/E command called from REXX scripts.
This command acquires the FlashCopy information related to the specified volume from the storage
system, and stores the information into the FlashCopy information structure that was specified by
the STEM parameter.
If the specified volume is not found, or an I/O error occurred and the storage system information
cannot be acquired, this command creates an error message in the command return configuration
structure, and then returns a return code other than 0.
This command can be used for volumes of the following models on which FlashCopy Mirror Version
2 is installed:
HP StorageWorks XP12000/XP10000 Disk Array
HP StorageWorks XP24000/XP20000 Disk Array
HP StorageWorks P9500 Disk Array
214 CLI Commands
lists the return codes to be returned when the YKEXPORT command terminates.
Meaning
The command completed normally. Contents of the copy group definition file were
output to the CSV file.
No copy pairs were defined in the specified copy group. No data was output to
the CSV file.
The input file was invalid.
An error occurred during file I/O processing.
Termination due to invalid parameters.
An error occurred during REXX processing.