Executing Ykwatch - HP StorageWorks P9000 Reference Manual

NOTE: Do not execute the YKDELETE command during planned outage operation (when switching
the P-VOL and S-VOL). To dissolve the copy pair, switch the P-VOL and S-VOL again, return the
P-VOL to the primary site (restore normal operation), and then dissolve the copy pair.

Executing YKWATCH

If w is specified in the AC column in the Manage Copy Groups panel, the YKWATCH command to
monitor the volume status transition will be executed and the Watch Options panel for specifying
parameters of the YKWATCH command is displayed. The value is used as a background job for
submitting. JCL uses a value indicated in the Set Defaults panel.
Figure 129 (page 169)
Figure 129 Watch Options Panel
"Contents of the Watch Options Panel" (page 169)
Table 87 Contents of the Watch Options Panel
Item
Copy Group ID
Watch transition to
1
Timeout Hours
Timeout Minutes
SEND Option
1 The sum total of the values specified in Timeout Hours and Timeout Minutes is specified for the TIMEOUT parameter
(timeout value) of the YKWATCH command. If the sum total value exceeds 16,666,666 minutes, execution of the
command results in an error.
shows the Watch Options panel.
Description
Copy group ID
Specify the waiting status for the YKWATCH command by using the number.
Duplex: Waits for the volume to change to the DUPLEX status.
Suspend: Waits for the volume to change to the suspend status.
Simplex: Waits for the volume to change to the SIMPLEX status.
Specify the value for the TIMEOUT parameter (timeout value) in hour (0 to 999999).
1
Specify the value for the TIMEOUT parameter (timeout value) in minute (0 to 9999).
Specify the USER, OPERATOR, or CN parameter of the YKWATCH command.
describes the items in the Watch Options panel.
Manage Copy Groups Panel (Copy Group Operation) 169